LASER POINTER
With Flexi Control Module
Laser pointers can be an effective aid to communication by allowing the user to point out objects, signs or symbols on a message board communicator.
The laser can be worn with the supplied headband or glasses clip, or can be attached to any part of the body as required.
Most lasers on the market do not have an ON/OFF switch that is easily accessible. To overcome this problem Technical Solutions has developed a Flexi Control Module which controls the switching of the laser pointer.
CONTROL MODULE
The control module allows you to use any of our special purpose switches to
turn the laser on and off. It also supplies power to the laser pointer.
MODES OF OPERATION
Latching On/Off Mode (push on push off )
- Select the 'Latch' mode with the toggle switch.
- The device will now start with one switch push and stop with the next.
Instant Mode (on when pressed, off when released)
- Select the 'Timer' mode with the toggle switch.
- Turn the ‘Timer Adjust’ knob anticlockwise to minimum.
- The device will now start when the switch is pressed and stop when the switch is released.
Timer Mode: (on when pressed, off after a few seconds)
- Set up as for Instant Mode.
- Now turn the ‘Timer Adjust’ knob clockwise to increase the delay before stop.
- The device will now start when the switch is pressed and stop after an
adjustable delay of up to about one minute.
